| General Information |
| Unit will not turn on (No power) |
Yellow or Red wire not connected or incorrect voltage
Check connections for proper volatge (11-16VDC)
Black wire not connected - Check connection for ground.
Fuse blown - Replace fuse with proper size fuse |
 |
| Unit has power but no sound. |
One or more speakers wires may be touching each other or touching chassis ground
Insulate all bare speakers wires from each other and chassis ground |
|
| Unit blows fuse |
Yellow or Red wire touching chassis ground - Check for pinched wire
Speaker wires touching chassic ground - Check for pinched wire.
Incorrect fuse rating - Replace fuse with correct rating |
|
| Unit has audio but no video |
Parking brake safety circuit not connected - Check connections at parking brake
Parking brake not applied - Apply parking brake |
|
| No video display when in reverse |
Reverse circuit not connected - Check connections at reverse lamp
Rear view is set to OFF - Set rear view to ON. |
|
| IR remote does not work |
|
Dead battery in remote control - Replace battery |
|
| Excessive skipping |
Unit is not mounted properly - Check mounting sleeve and or dash kit
Physical defect in media - Check media for scratches |
|
| ERR-DISC appears on display |
|
Focus error or disc is in upside down - Eject disc or RESET radio) |
|
| Are aftermarket adapters needed for installation? |
| In some cases aftermarket adapters will be required for installation for retaining factory amplifiers and other factory applications such as steering wheel controls and communications. |
|
